Author Previous Topic Topic Next Topic  
verticallimit
Chief Engineer


589 Posts
Posted -  25-11-2010  :  20:34:56
Help wanted

I'm about to start by making a part of the cockpit, and will ask if I can reduce this green dimension from 561 mm and down to 330 mm

 

NOTE: Some of the dimensions do not match


Med venlig hilsen / Best regards

Claus

 

Author Replies  
sisoffi
Mr


218 Posts
Posted - 26-11-2010 : 00:38:58
Klaus,

if you havent original 80 seats you can down the size. 

For the originale seats it must respect the 20cm.

Regards,

Simone


Go to Top of Page
crashdog
Software Engineer


249 Posts
Posted - 26-11-2010 : 10:05:10
as far as I understand the picture, it's not about the 20 cm height but the depth of the place where the rudders are ? In that case it depends on the lenght of your legs or how far back you can place your seat. It's a bit difficult to see on the pic what's actually ment.

Gery
Go to Top of Page
verticallimit
Chief Engineer


589 Posts
Posted - 26-11-2010 : 15:28:06


quote:
crashdog wrote:
as far as I understand the picture, it's not about the 20 cm height but the depth of the place where the rudders are ? In that case it depends on the lenght of your legs or how far back you can place your seat. It's a bit difficult to see on the pic what's actually ment.

Gery

Thats right, it's the depth for the rudder pedals.

Now i use CH rudder pedals, but i hobe to replace it whit original pedals sometime in the future.

What is the minimum depth for the original rudder pedals, and how far is the pedals placed from the MIP botom front edge.


Med venlig hilsen / Best regards

Claus

 

Go to Top of Page


Set us as your default homepage Bookmark us Privacy   © 2009 MD-80 Cockpit Project - All Rights Reserved. Design by: R.Frost SkyPortal.net Go To Top Of Page

Page load time - 0,391